Animated RainWaterdrop Material 虚幻4.17-4.27,5.0

支持引擎版本4.17-4.27,5.0

Warning: Because of a bug stated here, material overlay volume doesnt work right on 4.22 and 4.23. That bug fixed on 4.24.2.
General flow speed: Set 0 to stop all flowing.
Mask general flow speed: If general flow speed is not 0, this will set the general speed of vertical flow piles.
Bottom layer flow speed: Set 0 to stop 1/3 of drops.
Bottom mask flow speed: This will set the partial speed of vertical flow piles on bottom layer. Set it 0 to hide 1/3 of vertical flows.
Middle layer flow speed: Set 0 to stop 1/3 of drops.
Middle mask flow speed: This will set the partial speed of vertical flow piles on middle layer. Set it 0 to hide 1/3 of vertical flows.
Top layer flow speed: Set 0 to stop 1/3 of drops.
Top mask flow speed: This will set the partial speed of vertical flow piles on top layer. Set it 0 to hide 1/3 of vertical flows.
IOR: Index of refraction value
Opacity-control: Material opacity value
Specular amount: Material specular value
Static speed: This value will set the flow speed of tiny drops between static drops.
Static drop on?: Set it to 1 for horizontal surfaces that has no flow. (General flow speed must also set to 0)
Static drop speed: This is the refresh rate of changing positions of the drops which looks like rain fall on surface.
UV multiplier: Tile multiplier of the general Material.


警告:由于这里的一个bug，材料叠加量在4.22和4.23上不能正常工作。该错误已在4.24.2修复。
一般流速:设置0为停止所有流量。
掩模总流速:若总流速不为0，则设置垂直流桩的总流速。
底层流速:设0，停止1/3滴。
底掩模流速:设置底层垂直流桩的局部流速。将其设置为0以隐藏1/3的垂直流。
中间层流速:设为0，停止1/3滴。
中间掩模流速:设置中层垂直流桩的局部流速。将其设置为0以隐藏1/3的垂直流。
顶层流速:设置0为停止1/3滴。
顶掩模流动速度:设置顶层垂直流动桩的局部速度。将其设置为0以隐藏1/3的垂直流。
IOR:折射率值
不透明度控制:材质的不透明度值
高光量:材质高光值
静态速度:此值将设置静态液滴之间的微小液滴的流动速度。
静电降落?:对于没有流动的水平表面设置为1。(一般流速也必须设为0)
静态水滴速度:这是水滴位置变化的刷新率，看起来像雨滴落在地面上。
UV倍增器:瓷砖倍增器的一般材料。

下载地址

• 

  Animated RainWaterdrop Material .rar

  2024-1-19 15:44 大小：178 Bytes 下载次数：0 售价：26 银币

  记录